19
432-LIPPERT (432-547-7378)
Rev: 08.29.22
Quick Drop Stabilizer
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0004455
Preparation
1.
Be sure to park the trailer on solid, level ground.
2.
Clear all stabilizer leg landing locations of debris and
obstructions. Locations should also be free of depressions.
3.
When parking the trailer on extremely soft surfaces,
utilize load distribution pads under each stabilizer leg.
4.
People and pets should be clear of trailer while
operating the stabilizers.
Extending Stabilizers
1.
Disconnect the safety chain
(Fig. 34A)
from
the footpad
(Fig. 34B)
.
NEVER LIFT THE TRAILER COMPLETELY OFF THE
GROUND. LIFTING THE TRAILER COMPLETELY OFF
THE GROUND CREATES AN UNSTABLE CONDITION
THAT COULD RESULT IN PROPERTY DAMAGE AND
PERSONAL INJURY.
2.
Using a
3/4
” socket on a ratchet or cordless drill, turn the
hex coupler
(Fig. 35A)
clockwise to begin lowering the foot
pad towards the ground.
NOTE:
Use of an impact drill is not recommended and will
cause damage to the mechanism.
3.
After the footpad has extended to a point, it will be
necessary to pull the spring latch
(Fig. 36A)
and lower the
Quick Drop Leg
(Fig. 36B)
so that the foot pad
(Fig. 36C)
is
positioned as close to the ground as possible.
Fig.34
Fig.35
A
Fig.36
A
4.
Continue to turn the hex coupler clockwise until the
footpad touches the ground and resistance is felt.
A
•
3/4
” socket
• Cordless or electric drill or
screw gun
Resources Required
Operation
B
B
C
