CURTMFG.COM
•
NEED ASSISTANCE?
•
877.287.8634
•
48641-INS-RB
•
PAGE 2
Mounting the Lunette Ring
Determine the optimal height of the
lunette ring.
Note:
This product is rated
for use in the rise position only as shown.
Do not use in the drop position.
Secure the lunette ring to the trailer channel
using the three 5/8" bolts, six washers and
three nuts. Tighten all hardware to 180 ft. lbs.
Note:
Never exceed the rated capacity of
the vehicle or lowest rated towing component.
BEFORE EACH USE:
Inspect the unit for proper
operation and worn, damaged or missing parts.
Replace parts as required or when the unit's
wear exceeds 1/8" from the original surface.
Unlocking the Lunette Ring
Ensure the locking pin is in the unlocked
position prior to hooking up the trailer.
Remove the padlock. Lift and turn the
locking pin to the side, 90 degrees, as shown.
Reinsert the padlock to keep the locking pin
secure during travel.
Locking the Lunette Ring
Drop the locking pin into the position
shown to the right. Install a padlock
(not included) into the locking pin.
