Rev: 08.30.22
Page 20
CCD-0006500
Programming Additional Key-Fobs (Remotes)—Optional
1.
Locate the Program Button (Fig. 8) on the RF Receiver.
2.
Press the Program Button until the red Status Light (Fig. 8) illuminates, then release the button and the
Status Light will turn off.
3.
Within five seconds, press any button on the key-fob (remote) (Fig. 6). Verify that the RF receiver Status
Light blinks.
4.
Repeat steps 1 and 2 for each additional remote.
5.
Verify that each remote has been successfully programmed.
NOTE:
To delete all key-fob remotes stored in memory, press and old the Program Button for
approximately five seconds until the red Status Light turns off.
Fig. 8
Status Light
Program Button
Helm Switch Down
Helm Switch Up
Motor #2 Dark Blue Wire
Motor #2 White Wire
Override Switch
Battery Ground (-)
Motor #1 Dark Blue Wire
Motor #1 White Wire
Battery Positive (+)