9
lci1.com
574-537-8900
Rev:05.11.21
CCD-0003934
Power Pro Max
™
(Portable Power Cleaner)
Installation and Owner’s Manual
(For Aftermarket Applications)
What is happening?
What is happening?
Why?
Why?
What should be done?
What should be done?
Washer does not
turn on.
Discharged battery.
Remove and recharge battery. Reinstall fully charged battery into
handle assembly.
Battery not engaged.
Remove and reinsert battery into handle assembly.
Lower than expected
water pressure.
Clogged water filter.
Remove, inspect, clean and reinstall water filter.
Blocked water supply line.
Remove, inspect, clean and reinstall water supply line.
Loose water supply line.
Disconnect and reinstall water supply line into handle assembly.
Water supply low or empty.
Replenish water supply.
Little or no additive
dispenses when set to
Foam mode.
Loose additive
bottle connection.
Remove and reinstall additive bottle.
Empty additive bottle.
Remove additive bottle, replenish additive, then reinstall bottle.
Additive bottle leaks.
Loosely connected bottle.
Remove additive bottle, then carefully reconnect bottle onto
the nozzle.
Damaged bottle.
Remove additive bottle and inspect entire container for cuts,
punctures or damaged connector. Replace bottle if damaged.
No spray dispenses
when set to a water
mode or Foam mode.
Clogged nozzle, nozzle
extension or both.
If applicable, remove additive bottle from nozzle. Disconnect
nozzle from nozzle extension or handle assembly. If used,
disconnect nozzle extension from handle assembly. Inspect
nozzle, and nozzle extension if used, for obstructions. Clear any
obstructions, then reinstall nozzle, and nozzle extension if used. If
applicable, reinstall additive bottle.
Damaged nozzle, nozzle
extension or both.
If applicable, remove additive bottle from nozzle. Disconnect
damaged nozzle from nozzle extension or handle assembly.
If used, disconnect damaged nozzle extension from handle
assembly. Replace damaged nozzle, nozzle extension or both, if
necessary. If applicable, reinstall additive bottle.
Troubleshooting
Remove battery pack from handle assembly prior to
servicing the portable power cleaner.
Reinstall battery pack into handle assembly only after
troubleshooting issue has been resolved and normal
portable power cleaner operation is ready to resume.
Refer to the following troubleshooting table for specific
issues. If necessary, contact Lippert with additional
questions or concerns.