7
lci1.com
574-537-8900
Rev:05.11.21
CCD-0003934
Power Pro Max
™
(Portable Power Cleaner)
Installation and Owner’s Manual
(For Aftermarket Applications)
Battery
1.
Make sure the rechargeable 2.6 Ah MAX lithium ion
(Li-ion) battery is fully charged.
NOTE:
When the battery is fully charged, three blue
indicator lights
(Fig.12B)
will come on solid (no flashing).
When charging, indicator lights will flash.
2.
Make sure the trigger lock is still in its locked,
protruding position.
3.
Install battery. Refer to Battery Pack procedure in the
Assembly section.
Water Supply
Place the water supply line, with particle filter attached, into
a clean water source.
Using the Portable Power Cleaner
DO NOT OPERATE NEAR AN ELECTRICAL POWER
SOURCE SUCH AS AN ELECTRICAL OUTLET OR
WIRING. SPRAY CONTACTING ACTIVE ELECTRICAL
COMPONENTS CAN CAUSE PERSONAL INJURY FROM
AN ELECTRICAL SHOCK OR BURN.
DO NOT DIRECT OPERATING POWER CLEANER
NOZZLE AT PEOPLE OR PETS. HIGH WATER
PRESSURE CAN CAUSE PERSONAL INJURY TO
EXPOSED SKIN AND SEVERE INJURY TO PETS.
Designate the intended location/object on which to use
the portable power cleaner, then visually verify that no
people, pets or active electrical power sources or exposed
electrical wiring are within range of potential water flow
or overspray.
1.
With the nozzle pointed in a safe direction, press and
hold the trigger lock, then squeeze the trigger to identify
the current pressure setting.
NOTE:
The trigger lock must be activated prior to any
operation to prevent accidental use.
2.
If necessary, select the appropriate pressure mode for
the designated task by pressing the pressure selector
button
(Fig.14A)
located on the top of the handle assembly.
NOTE:
The pressure selector button is marked AUTO and
ECO. AUTO is the high pressure mode and ECO is the low
pressure mode. The last selected pressure mode remains
in effect until the selector button is pressed again.
A.
AUTO (high pressure) mode; develops 520 psi at
0.67 gpm flow. When in AUTO mode, the portable
power cleaner will run for approximately 26 minutes and
use approximately 14 gallons of water; dispensing at
approximately 0.55 gpm.
B.
ECO (low pressure) mode; develops 320 psi at
0.53 gpm flow. When in ECO mode, the portable power
cleaner will run for approximately 35 minutes and
use approximately 16 gallons of water; dispensing at
approximately 0.47 gpm.
Fig.14
A
low pressure
high pressure
