Lippert SlimRack, Owner'S Manual

Rev: 01.07.22 

Page 18

CCD-0001459

D. 

Once the slide-out room is retracted, secure the slide-out room in-place by:

I. 

Re-installing the motors. If there is a retaining spring, make sure the end of the retaining 

spring is re-hooked to the motor spring clip (Fig. 20).

II. 

With the motor retainer fully engage, tighten the motor retaining screw, until resistance is felt 

on the wrench. Be careful not to over tighten the screw (Fig. 21).

III. 

Make sure motor is properly seated with no gap between the mounting bracket and block 

(Figs. 20 and 21).

E. 

Have the slide-out room serviced by an OEM-authorized dealer as soon as possible. Do not 

operate the slide-out room until service is complete as damage to the slide-out room may result.

2. 

Manually retract the slide-out room by turning the 

1/2”

 square drive shaft of each vertical channel assembly.

A. 

Remove the motor. Follow steps 1-6 of the Manual Override Mode.

B. 

Access the 

1/2"

 square drive shaft (Fig. 23) of each vertical channel.

C. 

Using a 

1/2”

 8-point, star socket and alternating from one side to the other, turn the 

1/2”

 square 

drive shaft to retract the slide-out room. 

NOTE: 

A 15 mm 12-point socket is an option if the 

1/2”

 8-point star socket is not available. Use caution, as 

the 15 mm 12-point socket does not fit as snug as the 

1/2”

 8-point socket.

D. 

Once the slide-out room is retracted, secure the slide-out room in-place by:

I. 

Re-installing the motors. If there is a retaining spring, make sure the end of the retaining 

spring is re-hooked to the motor spring clip (Fig. 20).

II. 

With the motor retainer fully engage, tighten the motor retaining screw, until resistance is felt 

on the wrench. Be careful not to over tighten the screw (Fig. 21).

III. 

Make sure motor is properly seated with no gap between the mounting bracket and block 

(Fig. 20 and 21).

E. 

Have the slide-out room serviced by an OEM-authorized dealer as soon as possible. Do not 

operate slide-out room until service is complete as damage to the slide-out room may result.

Drive Shaft

Spur Gear

Gear Rack

Drive Shaft

Fig. 23