Rev: 06.29.22
Page 5
CCD-0004431
Installation
Secure Threshold Plate
1.
With the step extended in the down position, place the SolidStep® Levitate assembly inside the
doorframe threshold.
NOTE:
Make sure the step threshold plate (Fig. 4A) is placed firmly against the outside edge (red line) of
the door threshold (Fig. 3B). If not positioned flush against the outside edge of the door threshold,
the step assembly could prevent the door from closing.
Fig. 4
A
B
NOTE:
The leg extension is shipped attached to the top step with a cable tie and must be temporarily
installed before complete step installation.
A. Remove the leg extension from the step by cutting the cable tie.
B. Pull the spring loaded plunger (Fig. 3B) and insert the leg extension into the receiver. Do not let
the spring loaded plunger engage with any of the holes.
C. Insert a 3/16" temporary pin or tool (Fig. 3A) into the hole above the spring loaded plunger
(Fig. 3B) to secure the leg extension.
NOTE:
Temporary pin will be removed once step and lift assist are fully installed.
Fig. 3
A
B
Back side of SolidStep Levitate
Prior to Installation
• Verify that the trailer is on level ground.
• Verify the floor of the trailer has sufficient backing material for securing the SolidStep.
• Remove all parts and pieces from shipping packaging. Caps and detent pins are included.
