Customer Training Guide
Pre-Launch Wave Glider® SV3
08033 Rev A
13
Turning On/Off APU’s:
(Option 1)
SV3 Commands
– Devices – Either G1, G2, or G3 depending on what it's plugged
into
– Power On Expansion Port (ON) – Power Of Expansion Port (OFF)
(Option 2)
OBSP
– Operate – Power Devices – Turn on G port that the APU is plugged into.
Domain Status:
(Option 1)
OBSP
– Status – Overall – AMPS Manager.
Note: Expansion port (G1,G2, and G3) payloads are controlled by a PDC board (Power Domain
Controller).
(Option 2)
WGMS - SV3 commands
– Amps Manager – Domain Statuses – Commands
Log (Bottom of WGMS Home page)
– Once Acked, Hover over Combined Acts to view
Pressure and Temperature
Host = CCU
Thrudder = Thrudder
Bat = APU
Payload = Payload/Unknown
Chapter 7. Float
Reference the (Torque Specs for SV3 Fasteners) document for tools needed and torque specs.
Wet-mates connected/lubed:
All connectors were installed with 3M Silicone Lubricant Spray (or appropriate
equivalent, i.e. Dow Corning 4). Inspect for any damage in the system.
