2
Introduction
The Digidown device downloads data from digital tachograph vehicle units
(VUs) from all current tachograph manufacturers. Data downloaded from
the VU is stored on an SD memory card and can be uploaded via Bluetooth
to wherever it is required.
Three types of download are available:
ALL VU
Downloads all contents from the VU.
LATEST VU
Programmable. Options include: number of days of
activity data plus a selection from events & faults, detailed
speed and technical information and can include a
download of a driver card inserted in the VU.
CARD
Downloads a Driver Card inserted into the VU.
Initial Set Up
In order to operate the Digidown Blue successfully:
Insert a compatible SD card in the device. A suitable ready-formatted
SD card is supplied with the unit.
In order to read tachograph cards direct into the unit and use any of
the Bluetooth functions a pair of AA-size batteries is required. These
are also supplied with the unit. Please observe the correct polarity
when inserting the batteries.
To use the Bluetooth Upload function, follow the instructions under
“Setup Data Upload Using Mobile Phone”
.
To use the Bluetooth Remote Authentication function, follow the
instructions under
“Setup Remote Authentication Using Mobile
Phone”
.
Download VU and Driver Card Inserted in
VU
Please note that for any download to work including download of a Driver
Card in the VU (see note below) the VU needs to be authenticated. That is
achieved:
NOTE: DO NOT try to remove the latched memory card by pulling on the end of
the card. Push it back into the Digidown Blue. This will release the SD card and it
will spring out for easy removal.
