23
LPP PetRoL GeNset oPeRAtoRs' hANdbook
6. Pull on the starter rope with fast steady pull. As the engine warms up, readjust
the choke (1). On electric start models, turn the key switch to "START". Release
key switch after the engine starts.
dANGeR
Provide adequate ventilation for toxic exhaust gases and cooling air flow.
•
Do not start or run the generator in an enclosed area, even if door or
windows are open.
•
Engines give off carbon monoxide: an odourless, colourless and
poisonous gas.
•
Breathing carbon monoxide can cause nausea, fainting or death.
CAUtIoN
Allow generator to run at no load for 4 to 5 minutes upon each initial start-up
to permit engine and generator to stabilize.
APPLyING LoAd
•
This unit has been pretested and adjusted
to handle its full capacity. Before starting the
engine, do not connect the electric apparatus.
Apply load only after generator is running.
Voltage is regulated via the engine speed
adjusted at the factory for correct output. Do
not readjust the engine speed.
•
Wind the power output cord 2 or 3 turns
around frame.
CAUtIoN
▲ Be sure the total load is within generator rated output.
▲ Do not exceed the amperage rating of any one receptacle.
▲ Notice the power factor of load (see "SELECTING A GENERATOR")
