hinge assembly (B), originally located on the right, and flip it over as shown in the
figure below.
12.
Remove the covers on the left side of the appliance to attach the middle pivot
pin/hinge assembly (B) once you have flipped it over.
13.
Reposition the covers on the right side of the appliance to hide the screw locations
of the previous position of the middle pivot pin/hinge assembly.
14.
Position the upper door by fitting it over the middle hinge/pivot pin assembly (B)
and fit the upper hinge/pivot (A) into the receiving compartment on the inside
right-hand side of the door.
15. Hold the door flat (closed) against the body, centre it and then properly tighten
the screws.
16.
Do the same for the lower door by inserting the middle pivot pin/hinge assembly
(B) into the pivot-receiving compartment on the left side of the top of the lower
door and hold the door flat (closed) against the body.
17.
Position the lower hinge/pivot pin (C) by inserting the pivot pin into the pivot
receiving compartment on the left side on the underside of the door.
18.
Screw the lower hinge/pivot (C) on the left on the underside of the appliance,
without tightening the screws, so you can centre the door correctly, and then
tighten the screws.
19.
Return the appliance to its upright position, put the top back on and secure it.
EN
23
V.1.0
Summary of Contents for RDL 145-55b3
Page 2: ...13 V 1 0 2...
Page 87: ......
