10
QUICK START GUIDE
(CONT.)
Quick, step-by-step guide to get your LiteMat up and running.
© LITEGEAR INC. 2015
www.litegear.com
10. Adjusting the Center Mount
Begin by loosening the adjustable handle 180º while holding the LiteMat with your other hand. Next, pan, tilt,
or rotate LiteMat to the desired position and tighten the adjustable handle. The handle can be adjusted to allow
additional force by pulling out and rotating it into a new position.
9. Powering LiteMat directly
(without LiteDimmer)
Daylite and Tungsten LiteMats may be powered
directly from a power supply with no inline
LiteDimmer. If you did not buy your LiteMat in a
preconfigured kit, be sure the power supply is 12V
DC and capable of the appropriate amperage for
continuous duty. Next, untie the power supply
cables and connect the small, round female Barrel
connector from the power supply to the input of
the LiteMat (an extension may be required and/
or desired). Then, provide AC power to the power
supply. Your LiteMat should now be operational.
You can add
extensions
up to 24 feet in length, if
required and/or desired.
