background image

WARNING: CHOKING HAZARD - Small parts. Not For Children under 3 years

CAUTION: Do not touch the running model! Adult supervision is required!

LiteHawk SNAP Precautions - The LiteHawk SNAP is not intended for children under the age of 10 

unless closely supervised by an adult. Improper use may cause serious injury. Please read Li-Po 

Battery section before use. Do not fly in areas close to high voltage lines or crowds. Do not fly when 

windy. Do not fly in rain, snow or if there is lightning and/or thunder. Do not touch ANY moving parts 

while the model is powered.

CAUTION: Never insert any sharp objects, pins or screws into the model as this may puncture the internal 

battery!

SAFETY PRECAUTIONS

- Keep hands, hair and loose clothing away from moving parts when the model is powered ON.

- Turn off controller and SNAP when not in use.

- Remove batteries from controller when not in use.

- Parental guidance is recommended for the flight.

- Keep your SNAP in your sight so that you can supervise it at all times.

- New alkaline batteries are recommended for use in controller to obtain maximum performance.

- Your charger is tailor made for the Li-Po battery used in your LiteHawk SNAP. Do not use it to charge any battery 

other than that in the LiteHawk SNAP.

BATTERY SAFETY INFORMATION

- Requires 4 x 1.5V AA batteries (not included)

- Batteries are small objects.

- Replacement of batteries must be done by adults.

- Follow the polarity (+/-) diagram.

- Promptly remove dead batteries from the toy.

- Dispose of used batteries properly.

- Keep batteries dry.

- Remove batteries for prolonged storage.

- DO NOT incinerate used batteries

- DO NOT dispose of batteries in fire, as batteries may 

explode or leak.

- DO NOT mix old and new batteries or different types of 

batteries (i.e. alkaline/standard)

- Always replace the whole set of batteries at one time.

- DO NOT short-circuit the supply terminals

CARE AND MAINTENANCE - Controller

- Always remove batteries from the controller when it is not being used for a long period of time and disconnect 

battery from quadrocopter.

- Keep the toy away from direct heat or extreme cold.

- Do not expose the toy’s interior to water or moisture. This can damage the electronic assemblies.

Before charging the LiteHawk SNAP please read the following! 

- DO NOT leave the battery unattended during charging.

- DO NOT leave the battery plugged into the charger any longer than 2 hours.  If the charging light does not go 

out in this time, the charger or battery could be faulty - unplug immediately!

- DO NOT drain the battery to the point at which you can no longer lift off.  Stop using the SNAP when you begin 

to lose significant power.

- DO NOT install another battery without letting the motor cool first! 5-10 minutes is sufficient.

- DO NOT recharge the battery until it is cool to the touch! 10 minutes is sufficient.

- DO NOT store battery for longer than 24 hours without recharging to at least 65% capacity.

- Do not charge if battery or connector is wet.

- Remove the battery from the SNAP when charging.

Your LiteHawk SNAP is equipped with a Li-Po 

battery.

Special Li-Po Battery Instructions:

- Never charge battery unattended.

- Charge battery in isolated area. Keep away from 

flammable materials.

- Do not expose to direct sunlight. There is a risk of the 

batteries exploding, overheating or igniting.

- Do not disassemble, modify, heat or short circuit the 

batteries. Do not place them in fires or leave them in hot 

places.

- Only charge the batteries with the specified battery 

charger. 

- Only use the batteries in the device specified by 

LiteHawk.

- In the unlikely event of leakage or explosion use sand 

or a chemical fire extinguisher for the battery.

- Batteries must be recycled or disposed of properly.

- Keep battery dry.

- Do not leave plugged into quadrocopter when not in 

use.

- Do not charge if battery or connector is wet.

Do Not Fully Discharge the battery! Stop and recharge when your S begins to lose power!  Failing to do 

so will result in irreparable damage to the battery! During flight the LED lights will start to blink, this 

indicates the battery is running low.

LiteHawk SNAP Instruction Manual 

 

2

www.litehawk.ca

R

Summary of Contents for QUATTRO SNAP





















Reviews: