LiteHawk SNAP - Post Flight
- When you have finished using your LiteHawk SNAP you should first disconnect the Li-Po
battery, then switch OFF the transmitter.
- If you do not plan on using the quadrocopter for more than 24 hours, it is recommended
that you recharge the battery fully before putting it away.
- Remember to allow the battery to cool 10-15 minutes before recharging.
Video On/Off
Photo
Video
In image/video mode the light will turn to blue
With the SNAP synced and ready to fly, push the Video On/Off button. The power light will
change from solid red to blue.
Press the Video On/Off button to return to normal flight mode.
To see your pictures and video, simply remove the micro sd card from the SNAP. A gentle
push on the card will unlock it, now just pull it out.
Insert into the USB reader, then place the reader into a USB slot on your computer.
Remember to turn off your quadcopter and the controller.
Tip: If the blue light on the SNAP blinks red/blue this means that the micro sd card cannot
be read or it is full.
Press the Image button once. You will notice that the blue LED light near
the sd card slot will blink to red, then back to blue. The red blink
indicates that you have taken a picture! Try this a few times to practice.
Press the Video button once. You will notice that the blue LED light near
the sd card slot will STAY red - this means you are now capturing video.
Press the Video button again to stop capturing video.
LiteHawk SNAP Instruction Manual
9
www.litehawk.ca
R
