Page 9/9
configurations with respect to Part 2.1093 and different antenna configurations
The information on how to configure test modes for host product evaluation for different
operational conditions for a stand-alone modular transmitter in a host, , versus with multiple,
simultaneously transmitting modules or other transmitters in a host can be found at KDB
Publication 996369 D04
Appropriate measurements (e.g. 15 B compliance) and if applicable additional equipment
authorizations (e.g. SDoC) of the host product to be addressed by the integrator/manufacturer.
This module is only FCC authorized for the specific rule parts 15.247 listed on the grant, and
the host product manufacturer is responsible for compliance to any other FCC rules that apply
to the host product as being Part 15 Subpart B compliant.
The user manual of the end product should include
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate this equipment.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
The antenna(s) used for this transmitter must be installed to provide a separation distance of at
least 20 cm from all persons.
Label of the end product:
The host product must be labeled in a visible area with the following " Contains FCC ID:
PPQ-WN4646L".
The end product shall bear the following 15.19 statement: This device complies with part 15 of
the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
