page 8
10. Light Kit Assembly. (cont.)
Connect
WHITE
wire from switch housing to
WHITE
wire from light kit fitter. Connect
BLACK
(or
BLUE
) wire from switch housing to
BLACK
wire from light kit fitter. Be sure molex
connections snap together completely.
Align holes in light kit fitter with holes in switch
housing. Attach light kit fitter with screws that
were removed on previous page. Securely
tighten all 3 screws with Phillips screwdriver.
Secure 3 glass shades using thumb screws
provided in one of the hardware packs.
Do not
overtighten thumb screws as glass may crack or
break.
Install 3 candelabra base 60 watt max. bulbs
(included).
Important
: When replacing bulbs, please allow
bulb(s) and glass shade(s) to cool down before
touching them.
It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test fan
speeds with the pull chain on the switch
housing. Start at the OFF position (no blade
movement). First pull will set the fan to HI.
Second pull will set the fan to MEDIUM. Third
pull will set the fan to LOW. Fourth pull will again
set the fan to the OFF setting. Test lights with the
pull chain in the middle. If fan and/or lights do
(does) not function, please refer to
"Troubleshooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off
before
moving the
reverse switch. Set reverse switch to recirculate
air depending on the season:
- DOWN position in summer (
diagram 1
)
- UP position in winter (
diagram 2
)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important
: Reverse switch must be set either
completely UP
or
completely DOWN
for fan to
function. If the reverse switch is set in the
middle
position (
diagram 3
), fan will not operate.
Attach pull chain extensions supplied or custom
pull chain extensions (sold separately) to ends of
the pull chains.
11. Testing Your Fan.
glass
shade
bulb
light kit
fitter
reverse
switch
light
pull chain
extension
fan
pull chain
extension
thumb
screws
thumb
screw
switch
housing
diagram 1
diagram 3
diagram 2
black wire
black
(or blue)
wire
white
wire
molex connections
white wire
motor housing
