page 8
10. Light Kit Assembly (Optional). (cont).
Install two 6.5 watt medium base LED bulbs (included).
Important
: When replacing bulbs, please allow bulbs
and glass shade to cool down before touching.
Raise glass shade in order to guide pull chains through
appropriate holes in glass shade. Align threaded rod on
light kit fitter with hole in middle of glass shade and
push up gently allowing threaded rod to come through
hole. (
Be sure pull chain for fan operation does not rub
against bulb during operation
.) Replace rubber washer
and hex nut on threaded rod. Tighten hex nut but
DO
NOT OVERTIGHTEN hex nut as glass may crack or break.
Align hole in center of finial plate with threaded rod,
allowing pull chains to come through appropriate
holes in finial plate, and push up. Thread center pull
chain through hole in finial and secure glass shade to
light kit fitter by tightening finial.
Do NOT overtighten
finial as glass may crack or break.
If you wish to use your fan WITHOUT the light kit
,
remove hex nut and lock washer from threaded rod at
top of light kit fitter. Unscrew switch housing cap to
remove it from the light kit fitter. Then, gently feed
BLACK
and
WHITE
wires from light kit fitter through
hole in middle of switch housing cap.
Locate cap in one of the hardware packs and place cap
firmly into hole in middle of switch housing cap.
Align holes in switch housing cap with holes in switch
housing. Secure switch housing cap with 3 screws (and
star washers) removed at the beginning of Step 10,
page 7. Tighten all 3 screws securely.
finial plate
glass shade
finial
threaded rod
light kit fitter
fan pull
chain extension
light pull
chain extension
switch housing
rubber washer
switch housing cap
light kit fitter
WHITE
BLACK
hex nut
lock washer
switch housing cap
cap
switch housing
bulb
hex nut
