A fully discharged Battery Pack will take
about 1 hour to fully charge.
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Charging Battery Pack
1.
Place Battery Charger on a dry, flat,
fireproof surface indoors.
NOTE:
Allow battery to cool completely before charging.
2.
Examine Battery Pack.
Do not charge a
cracked, open, or leaking Battery Pack, or
charge a non-recommended type of Battery
Pack.
3.
Battery Pack is designed to fit this Charger
specifically. If Battery Pack does not fit
Charger properly, do not try to insert it.
Do
not force Battery Pack into the Charger.
4.
Plug Charger into a grounded, 120 VAC, 60 Hz
receptacle. The green LED will blink, showing
that power is supplied to the Charger.
5.
Slide Battery Pack onto Charger. Red LED will
light continuously while charging.
NOTE:
NOTE:
While charging, Battery Pack and Charger
may become warm to the touch and the Charger
′
s
fan may come on. This is normal.
6.
Green LED will light continuously when Battery
Pack is charged. Unplug Charger and remove
Battery Pack when finished.
7.
Allow Battery Pack to cool completely before
use.
I
nstalling and Removing Battery Pack
1.
To install: Slide Battery Pack into slot on back
of Chainsaw until it clicks into place.
2. To remove: Press both Battery Pack Release
Buttons and pull Battery Pack out of slot.
Battery
Pack
Battery Pack
Release
Buttons
Figure E: Battery Pack
Page 13
U1CS21113
WWW.LITHELI.COM
