2016 | Lithionics Battery LLC | SOCV6 REV0
PRE-RELEASE
5
Weather Resistant Display Port Connection:
When connecting the SoC Display via the weather resistant port on the front of the sender unit it is
especially important to pay special attention to the screw down connector.
1.
Locate the two indentations highlighted in green below.
2.
Connect the screw connector to the panel interface with the two highlighted indentations
mating with each other.
3.
While pressing the ring down lightly, rotate the ring counter-clockwise until you feel a light
click. This aligns the ring threading with the panels mating threads.
4.
Now turn the ring clock-wise to begin screwing the ring down. Keep note of any excess
friction which may indicate it is being cross-threaded. If this occurs stop immediately, un-
screw the ring and start over. Inspect the ring to be “square” compared to the panel.
