2862 Walnut Avenue, Suite D - Tustin, CA, 92780
Phone: 1.949.313.6340 • E
11
7.
Reinstall the riser clamps with the handlebar centered and at desired angle. Make sure the
handlebar harness rests between the handlebar risers and below the handlebar. Tighten
the riser clamp bolts and coupling nuts to a torque of 15-20 lb/ft.
8.
Install the brake levers using a 4mm Allen wrench to tighten the clamp bolt. Install the
front brake lever on the right side, near the throttle, and the left brake lever on the left
side. Route the brake lines in an appropriate manner that eliminates the risk of binding or
pulling.
NOTE: THROTTLE SHOULD NOT BE ATTACHED TO CLOSE TO BRAKE
LEVER.