Toll Free: 877-250-7729 www.Litter-Robot.com
15
Control Panel
1.
“Cycle” Button
Pressing the "Cycle" button starts the Litter-Robot
cleaning cycle. To stop the cycle, press any button
on the Control Panel. Press "Cycle" once again to
resume the cleaning cycle.
If you stopped the Globe during the cleaning cycle,
pressing "Fill" or "Empty" will return the Globe to
the home position.
2.
“Fill” Button
Pressing the "Fill" button on the Control Panel starts
a counter-clockwise rotation of the Globe to bring
the waste ports to the top. This position is
convenient for filling the Litter-Robot with litter.
Please see the section “Filling the Litter-Robot with
Litter” for details.
Toll Free: 877-250-7729 www.Litter-Robot.com
16
3.
“Empty” Button
The “Empty” cycle removes most litter from the
Globe, bypassing the sifting screen. This cycle is
convenient for removing the old litter prior to
cleaning the interior of the Globe.
You can read the details about removing litter in the
section “Cleaning and Maintenance”.
4.
Green Light (“OK/Waiting”)
This light indicates that the unit is OK and that the
Litter-Robot is ready for your cat.
5.
Yellow Light (“Cycling/In Use”)
The Litter-Robot is cycling (Cleaning cycle, Fill cycle,
or Empty cycle).
6.
Red Light (“Sensor/Timing”)
The red light indicates that the Cat Sensor has been
activated and the Litter-Robot is going through the
seven minute count-down before starting the
cleaning cycle. If the red light is flashing, an error
has occurred, please see the Troubleshooting
section for steps to take to solve this problem.
Note
If the Cat Sensor is tripped again within the seven
minutes of the count-down, the count-down timer
resets. The Globe will not turn until another seven
minutes have elapsed. You can cancel the "cat
detected" seven minute count-down (red light is on)
at any time by pressing any of the buttons on the
Control Panel.
