Make the bunk
You need: 4 x Double metal dowel and 8 x 2.5cm bolts
TWO people to lift upper bed onto the lower bed.
Fit 4 x double metal dowels into the top of the lower bed and connect 4 x 2.5cm
bolts into the lower metal dowel hole and leave loose.
lower the upper bed down onto the 4 metal dowels projecting out of the lower
bed. Once both beds are together insert the remaining 4 x bolts into the top metal
dowel holes. Some slight wiggling of the lower bolt can sometimes help the top
bolt to engage.
Once all 8 bolts are connected tighten using the allen key supplied.
Fit the mattress base (Lower bed)
34 wood screws (3cm)
Note: Please use TWO people to prevent scratching your bed.
Spread the mattress base out to full length on the mattress rails and screw every
bed lath to the bed supports.
Note: Please ensure that the bed lath fitted nearest to the bed end is positioned
tight upto the bed end.
x 34
