Make the drawer
2 x Small Cams 2 x small cam pins
Fix 2 small cam pins into each drawer front.
Insert 2 small cams into each drawer side, left and right (see image for orientation)
Gently slide the drawer sides over the cam pins, inserting the drawer base at the same
time (this helps with alignment)
Note: Base edge with corners removed locate into the drawer front.
Wheel position at the rear
x 2
Make the drawer
2 x Bolts 5cm and an Allen key
Orientate the drawer back with the groove facing down.
Align the drawer back so that the end dowels engage into the holes in each drawer
side. Once aligned, press the two drawer sides together to form the box. Insert 1 x bolt
into each drawer side and rotate to tighten.
Now rotate the cams in the drawer sides to secure the parts.
x 2
Slip the drawer into the carcass
