Making the bed frames.
12
x long Bolts
10cm
, 12 x Barrel Nuts, an Allen key
Orientate the bed ends with the middle holes at the rear of the bed.
Push one barrel nut into each mattress rail holes, aligning the slot head to the end
hole.
Slide each bolt through the bed end holes and into the holes in the end of each
mattress rail.
Image with bed entrance on the right, if entrance required on the left, swap the
mattress rails
. Twist the bolts to tighten the bed together.
Align
Tighten
rear safety
Mattress rail
Align
Tighten
rear safety
Mattress rail
Fit the rear rail
4
x long Bolts
10cm
, 4 x Barrel Nuts, an Allen key
Orientate the rear rail with the holes on the edge upwards and insert 4 x barrel nuts.
Now insert 4 x bolts through the legs, rotating them into the barrel nuts. Tighten the
fittings
holes upwards
Summary of Contents for Fargo HSP001
Page 1: ...Code HSP001 ...
