34
The live center is
LittleMachineShop.com part number 1189
. It has a 2 Morse
taper shank. This center fits the tailstock of the mini lathe.
The dead center is
LittleMachineShop.com part number 1188
. It has a 3 Morse
taper shank. This center fits the headstock of the mini lathe. The center has a
60 degree included point angle.
The lathe dog is
LittleMachineShop.com part number 1149
. This lathe dog has a
capacity of just over 3/8".
Steady Rest and Follower Rest
Steady and follower rests support small diameter work that would otherwise
flex too much. A steady rest mounts in a fixed position on the ways of the
lathe. A follower rest mounts on the carriage and moves with the cutting tool,
providing support where it is needed.
The steady rest is
LittleMachineShop.com part number 1197
. The steady rest
can support work up to 1.5" in diameter.
The follower rest is
LittleMachineShop.com part number 1198
.
Maintenance
Maintenance of the mini lathe is simple, but important. Regular maintenance
will keep your mini lathe working like new for many years.