The spot and flood LEDs can each be operated at 5 light output levels,
low, medium, medium plus, high
and
maximum
. The LEDs can be operated separately or blended together in any combination of these levels
(see table below), with the exception of maximum setting. Maximum setting is restricted to either flood LED
only or spot LED only, as a combination of both at this level of output rather misses the point!
While using the arrow buttons to select light level of the LEDs, you will note that the flood and spot LEDs light
up at significantly lower levels than during actual lamp operation! These levels are simply representative of the
5 power settings of each LED, but set at lower level in order to protect your vision when programming.
However, even at these lower levels direct eye exposure should be avoided.
(default
settings 1-4)
off
– spot
low spot
medium
spot
medium
plus spot
high spot
maximum
spot
off - flood
n/a
50 lumen
60 hours
150 lumen
20 hours
250 lumen
12 hours
675 lumen
4 hours
1000 lumen
2.5 hours (2)
low flood
50 lumen
60 hours
100 lumen
30 hours
200 lumen
15 hours
300 lumen
10 hours
725 lumen
3.5 hours
n/a
medium
flood
150 lumen
20 hours (1)
200 lumen
15 hours
300 lumen
10 hours
400 lumen
7.5 hours
825 lumen
3 hours
n/a
medium
plus flood
250 lumen
12 hours
300 lumen
10 hours (3)
400 lumen
7.5 hours
500 lumen
6 hours
925 lumen
2.5 hours
n/a
high flood
675 lumen
4 hours
725 lumen
3.5 hours
825 lumen
3 hours
925 lumen
2.5 hours
1350 lumen
2 hours (4)
n/a
maximum
flood
1000 lumen
2.5 hours
n/a
n/a
n/a
n/a
n/a
max. regulated light outputs,& approx. run times based on 6800mAh battery pack (see website)
Monkey M
ode ….. for Monkeys !!
Monkey Mode simplifies the operation of Nora3, for people who just want things super simple, or monkeys! To
select Monkey Mode, enter
<*(0)OK>
.
Monkey Mode allows a maximum of 3 light level settings (default settings 1-3 from above table), selected in a
forward loop with OFF at the end of the sequence
.
Monkey Mode has only one length of switch press
<push>
.
There is no distinction between short and long switch pushes. The Moon Mode and battery charge level
indicator are also disabled, except on initial connection of battery. The auto transport lock remains active.
Press switch twice
<push-push>
to escape from this little monkey trap! The number of light settings can still
be specified from 1-3, and the desired level of light output set for each. To exit Monkey Mode and restore
Nora3 to normal operation (at last stored setting), enter
<*(0)OK
>
. On exit,
Nora3 will retain (to memory)
changes made to Monkey Mode settings.
Restore Factory Default Settings
If at any point you get in a pickle, then enter
<#(0)OK>
to restore all Nora3 settings to factory default settings.