3
2
Before playing, an adult must install fresh alkaline batteries in the car and remote. Here’s how:
1. Using a Phillips screwdriver (not included) remove the screw and battery compartment cover from the
underside of the car.
2. Install four (4) fresh 1.5V AA alkaline batteries (not included) in the car making sure the (+) and (-) ends
face the proper direction as indicated inside the battery compartment.
NOTE: Car batteries are layered with two batteries inserted on the bottom layer and two remaining batteries above it.
Position ribbon inside the battery compartment as shown before installing batteries. Ribbon will aid in battery
removal when batteries need to be replaced.
3. Replace the compartment cover and tighten the screw.
BATTERY INSTALLATION
RACE CAR
REMOTE CONTROL
1. Using a Phillips screwdriver (not included) remove the screw and battery compartment cover from the
underside of the remote.
2. Install two (2) fresh 1.5V AA alkaline batteries (not included) making sure the (+) and (-) ends face the proper
direction as indicated inside the battery compartment.
3. Replace the compartment cover and tighten the screw.
QUICK START
Press both buttons up,
car will move forward. (Press both
buttons down, car will reverse.)
Press right button up,
car will turn right. (Press right
button down, car will reverse to the right.)
Press left button up, car will turn left.
(Press left button down, car will reverse to
the left.)
Press and hold buttons as shown,
car will spin in a circle. (Press and hold
opposite buttons, car will spin in the
opposite direction.)
1. To assure your car will pick up the correct frequency, switch the car ON first, then switch the remote control ON.
2. Place the car on the floor.
3. Press the buttons on the remote control as shown in the diagrams below.
NOTE: When finished playing, first turn off the car, then turn off the remote control.
IMPORTANT NOTE:
In the event of a malfunction, reset the item by removing and replacing the batteries. If function is still not
restored, replace the batteries with fresh alkaline batteries.
DRIVING THE TIRE TWISTER
DRIVE IT, SPIN IT, FLIP IT !
DRIVING THE RC CAR
1. Set the car inside the monster tire making sure the car tires straddle the ribs inside the monster tire.
2. Place the monster tire on the floor.
3. To assure your car will pick up the correct frequency, switch the car ON first, then switch the remote control ON.
4. Follow the remote control patterns below. As the car inside the monster tire moves, the monster tire will turn,
twist and spin!
5. While going forward, reverse the direction and the car will flip backward and forward inside the monster tire.
NOTE: When finished playing, first turn off the car, then turn off the remote control.
2x AA Batteries
1.5V AA/
LR6
1.5V AA/
LR6
Bottom Layer
Top Layer
RIBBON
1.5V AA/
LR6
–
1.5V AA/
LR6
+
1.5V AA/
LR6
+
1.5V AA/
LR6
1.5V AA/
LR6
1.5V AA/
LR6
1.5V AA/
LR6
