3
2
Before playing, an ADULT must install fresh alkaline batteries in the CAR and REMOTE. Here’s how:
1. Using a Phillips screwdriver (not included) remove the screw and battery compartment cover from the
underside of the car. (Fig. 1)
2. Install three (3) fresh 1.5V AA alkaline batteries (not included) in the car
making sure the (+)and (-) ends
face the proper direction as indicated inside the battery compartment. (Fig. 1)
NOTE: Car batteries are layered with one battery inserted on the bottom layer and the two
remaining batteries above it. Position ribbon inside the battery compartment as shown before installing
batteries. Ribbon will aid in battery removal when batteries need to be replaced.
3. Replace the compartment cover and tighten the screw.
BATTERY INSTALLATION
RACE CAR
REMOTE CONTROL
Fig. 1
1. Using a Phillips screwdriver (not included) remove the screw and battery compartment cover from the
underside of the remote. (Fig. 2)
2. Install two (2) fresh 1.5V AA alkaline batteries (not included) making sure the (+) and (-) ends face the proper
direction as indicated inside the battery compartment. (Fig. 2)
3. Replace the compartment cover and tighten the screw.
Fig. 2
QUICK START
X
X
X
X
Press both buttons forward,
car will move forward. (Press both
buttons back, car will move backward.)
Press right button forward,
car will turn left. (Press right
button backward, car will back
left
.)
Press left button forward, car will turn
right. (Press left button backward, car will
back
right
.)
X
X
Press and hold buttons as shown,
car will spin in a circle. (Press and hold
opposite buttons, car will spin in the
opposite direction.)
DRIVE IT, SPIN IT, FLIP IT !
DRIVING THE TIRE TWISTER
1. Set the car inside the monster tire making sure the car tires straddle the ribs inside the monster tire.
2. Place the monster tire on the floor.
3. To assure your car will pick up the correct frequency, switch the
car
ON first, then switch the
remote control
ON.
4. Follow the remote control patterns below. As the car inside the monster tire moves, the monster tire will turn, twist and spin!
5. While going forward, reverse the direction and the car will flip backward and forward inside the monster tire.
NOTE: When finished playing, first move the (
I
/
O
) switch on the car to
O
,
then move the (
I
/
O
) switch on the
remote control to
O
.
DRIVING THE RC CAR
1. To assure your car will pick up the correct frequency, switch the
car
ON first, then switch the
remote control
ON.
2. Place the car on the floor.
3. Press the buttons on the remote control as shown in the diagrams below.
NOTE: When finished playing
,
first move the (
I
/
O
) switch on the
car
to
O
,
then move the (
I
/
O
) switch on the
remote control
to
O
.
1.5V
A
A
/ LR6
1.5V
A
A
/ LR6
1.5V
A
A
/ LR6
1.5V
A
A
/ LR6
IMPORTANT NOTE:
In the event of a malfunction, reset the item by removing and replacing the batteries. If function is
still not restored, replace the batteries with fresh alkaline batteries.
RIBBON
