LIV LIVRBSKETTLE, Instruction Manual

OPERATING INSTRUCTION

Before use for the first time, remove possible manufacturing process    residues by several 
boiling cycles. Dispose this water.

The capacity of kettle is clearly marked on the kettle body, it should not be higher than the 
max line or lower than the minimum line
On filling water, care should be taken to avoid water column flowing on the kettle is outside 
surface.

Place the kettle on a stable flat surface.
Never heat the kettle on any wet surface, do not allow water to penetrate the electrical 
parts inside the kettle.
Do not position the kettle on or near hot surface or near open flames

Insert the main plug on the power cord into the wall socket.
Please take care that the power cord is well located and not in the path of anyone.
Push the restoring switch
The red indicator lamp lights up, it indicates that the kettle is in heating.

The kettle is automatically switched off several seconds after the water is boiling.
The red indicator lamp goes out as switch off.

After the kettle has switch off, it will need some time to cool down. After 15 minutes, the 
kettle can be switched on again manually. If the red indicator lamp still goes out after 
pushing the restoring switch. It may be the case that the temperature sensing controller
is still in hot condition and time must be given for it to cool down.

BEFORE USE FOR THE FIRST TIME

FILLING WATER

LOCATING

SWITCHING ON 

BOILING

RESTORING

-8-

•

•

•

•

•

•

•

•

•

•

•

•

their safety.
If electric kettle is without water. Please do not open “on/off” switch.
Children should be supervised to ensure that they do not play with the appliance.
To prevent damage to the power cord, do not let it pass over sharp corners or edges.
If the supply cord is damaged, it must be replaced by the manufacture, its service agent 
or similarly qualified persons in order to avoid a hazard.

-
-
-
-