Download the Application
Download and install the thermometer application
on your iOS / Android device.
You can download for free in Apple App Store or
Google Play Store
Search
« Livan Thermo App »
CAUTION
A typical smart device with a maximum
output power of 2 W yields d = 3.3 m at an
immunity level of 3 V/m
Establish a connection
Please turn on your Bluetooth on your iOS or Android
device.
Press On/Off on the thermometer at least 3 sec to
turn on the thermometer.
Lunch the App on your iOS or Android device and
follow the instruction for the application to establish
the connection with the Livan Bluetooth
thermometer BT-0512, then the devices will be
synchronize.
Once the connection has been established, the
temperature is show on the screen of the App on
your iOS or Android device.
Please turn off your airplane mode and active
Bluetooth on your iOS or Android device, or the
connection will be not restricted by calls
Measuring the temperature
Please put the steel sensor on aimpit to monitor
the temperature. Hold the position at least 10
min, to ensure correct measurement values.
To ensure a good connection between the
device and the iOS or Android device, the
distance between devices should not exceed
5 meters. Connection is more secure, if the
devices is located in the ipsilateral of body
In normal Bluetooth connection, the scope can
reach up to 10 m, the scope can be reduced by
obstacles. (E.g wall )
The application on the iOS or Android device
will show the measured temperature Value by
the thermometer
Instructions
Power ON by On/Off button(Press 3 sec), display
on for 5 sec, blue LED continue ON for 5 sec,
then put the sensor of the device on armpit to
start monitor the temperature.
The device wll continue monitor the tempera-
ture, when press On/Off button once, the deivce
will show the current temperature on display
If the measuring temperature is below 32℃,
there will show »Lo« on the display. If the tem-
perature is higher than 32℃, the value will be
show on the display directly. If the temperature
is higher then 42℃, there will show »Hi«.
If the measuring temperature is higher then
38℃, the LED on the device will flash red light
for 5 min, then the device will prompted again
when the temperature is increased by 0.5℃
After using, press the On/Off button for 5 sec,
the LED will flash red light for 5 sec, then the
device will shutdown to save battery power.
The extra wrist belt is using when the belt on the
thermometer may not long enough to tied.
Note
The applied part is the sensor head.
The device has automatic shutdown when
sensor doesn
’
t any temperature measured
for 30 min.( below 32℃).
Cleaning and Maintenance
To clean the thermometer, use a soft cloth
slightly dampened with mild soapy water or
70% isopropyl alcohol. Do not let water get into
the unit. Only use the unit again when
completely dry.
Never use aggressive cleaning agents, thinners,
benzine or tough brushes.
Remove the batteries if you do not wish to use
the unit for an extended period of time.
Otherwise there is a danger that the batteries
may leak.
