8 GB/IE/NI
Keep the lamp and the mains cable away from
open fire and hot surfaces.
Ensure the mains cable does not pose a tripping
hazard.
Do not kink the mains cable or run it over sharp
edges.
The LED filament light bulb is not
dimmable.
For your safety
Position the lamp so it is protected from mois-
ture and dirt.
Never place the lamp where it can fall into a
bath or washbasin.
Never reach for an electrical appliance which
has fallen into water! In this event, immediately
unplug the mains plug from the power socket.
Always be alert! Always pay attention to what
you are doing and use common sense.
Do not cover the lamp with objects. Excessive
heat build-up can result in fire.
Do not look into the light bulb from a close
distance during operation.
Do not use optical instruments to look at the
light source.
In order to disconnect the lamp completely
from the power supply, the mains plug must be
removed from the socket.
Initial use
Assembling the lamp
(see illustration)
Attention:
The threaded ring
2
is pre-installed
on the lamp socket
4
; please remove.
Screw the first three upper support tubes
6
into the tripod socket
5
.
Screw the next three middle support tubes
7
into the upper support tubes
6
.
Pull the cable out of the one bottom support
tube
8
and screw into the middle support
tube
7
.
Screw the remaining two lower support tubes
8
into the middle support tubes
7
.
Adjust the lampshade
3
to the correct posi-
tion.
Secure the lampshade
3
with the ring nut
2
.
Be sure all are positioned correctly.
Screw the light bulb
1
clockwise into the
lamp socket
4
on the tripod socket
5
. Use a
clean, fluff-free cloth when inserting the light
bulb
1
.
Plug the mains plug
9
into a properly in-
stalled power socket.
Your lamp is now ready to use.
Switching the lamp on / off
Press the ON / OFF foot switch
10
to switch
the lamp on and off.
Changing light bulbs
DANGER OF ELECTRIC
SHOCK!
First unplug the mains plug
9
from the
power socket.
CAUTION! RISK OF BURNS DUE TO
HOT SURFACES!
Allow the lamp to cool down
completely.
Use a clean, fluff-free, dry cloth when replacing
the light bulb
1
.
Unscrew the defective light bulb
1
out of the
lamp socket
4
on the tripod socket
5
, turn-
ing anti-clockwise.
Screw a new light bulb
1
(see “Technical
data“) clockwise into the lamp socket
4
on
the tripod socket
5
.
Plug the mains plug
9
into a properly installed
power socket.
Your lamp is now ready to use.
