11
GB
The included ground stake
10
is suitable for mounting in soil (e.g. lawn
or flower bed). The soil must be soft enough to push the ground stake
in without applying force (e.g. hammer strike), but must be firm enough
at the same time to ensure the product is securely fixed.
Installation
When selecting the mounting location, pay attention to the following:
Make sure that the spotlight
4
illuminates the desired area. You can
move the spotlight vertically.
Make sure the motion detector
9
covers the desired area. The motion
detector has a maximum coverage range of 10 m, with a coverage
angle of about 180 ° (depending on the mounting height – a height
of 1.80–2.50 m is ideal).
Make sure the motion detector
9
is not illuminated at night by street
lighting. This can influence its functioning.
Connecting the product
Open the connection box
6
by using a crosshead screw driver to
loosen the fixing screws
12
of the connection box
6
(Fig. B).
Run the flexible cord, type H05RN-F 3G 1.0 mm
2
, through the cable
gland
13
and into the connection box
6
. The length for the flexible
cord should not exceed 2.5 m. Open the terminal block
15
by using a
slot head screw driver to loosen the fixing screws.
Attach ferrules and cord anchorage
14
to the wires of the cord. Connect
them with the terminal block
15
in the connection box
6
. Pay attention
to the markings on the terminal block
15
(L for live, N for neutral and
for the earth wire) (Fig. E). Close the terminal block
15
again by
Summary of Contents for 288476
Page 3: ...A 5 6 11 10 8 4 2 3 1 B 6 9 7 12...
Page 4: ...E 15 C D 14 13 16 17...
Page 82: ...F G 18...
