13
GB
Insert the product with the ground stake far enough into the ground
so it is firmly seated. Make sure it is firmly placed. Do not use exces-
sive force, e.g. strike with a hammer. This could damage the product.
Align the spotlight into the desired direction. For this, you may need to
slacken the locking screws
7
of the hinge joint. After alignment, tighten
the locking screws of the hinge joint again, to ensure a secure hold.
Re-install the fuse for this circuit or switch on at the circuit breaker
(I position) in the fuse box.
Start-up
Adjusting the motion detector
Depending on the pre-adjustments of the motion detector
9
, the spotlight
4
will switch itself on for a certain period of time as soon as the motion
detector
9
detects movement. These pre-adjustments are made using the
three controllers on the underside of the motion detector
9
(Fig. H).
Setting the lighting duration
Turn the TIME rotary control
19
on the bottom of the motion detector
9
clockwise to increase the duration of illumination. The lighting du-
ration can be adjusted within a time window of approx. 5 seconds to
7½ minutes.
Summary of Contents for 288476
Page 3: ...A 5 6 11 10 8 4 2 3 1 B 6 9 7 12...
Page 4: ...E 15 C D 14 13 16 17...
Page 82: ...F G 18...
