11
GB
Only use the same type of
batteries / rechargeable bat-
teries. Do not mix used and
new batteries / rechargeable
batteries.
Remove batteries / recharge-
able batteries if the product
will not be used for a longer
period.
Risk of damage of the
product
Only use the specified type
of battery / rechargeable
battery!
Insert batteries / rechargeable
batteries according to polarity
marks (+) and (-) on the bat-
tery / rechargeable battery
and the product.
Clean the contacts on the
battery / rechargeable battery
and in the battery compart-
ment before inserting!
Remove exhausted batteries /
rechargeable batteries from
the product immediately.
Mounting
(see Fig. A)
Note:
Clean the surface well
onto which you wish to mount the
product. The surface must be
clean, free from grease and dry.
The adhesion of the double-sided
adhesive strip
5
,
10
may other-
wise be limited.
Note:
Before use, check on a hid-
den area of the surface, whether
the adhesive can cause damage.
Peel the protective film off the
adhesive strip on the back of
the LED strip
2
and secure
the LED strip in the desired
location.
Secure the LED controller
4
with the included double-sided
adhesive strip
5
or the in-
cluded screws
8
.
Connect the power supply
3
with the LED controller
4
.
Then connect the LED control-
ler
4
to the LED strip.
Note:
When connecting the
LED controller
4
with the
LED strip, be sure to match
up the VGGD mark on the
