11
GB/IE/NI
marking of the mounting plate ( UP) is
showing vertically upward (Fig. A).
Note:
The enclosed mounting material is
suitable for ordinary masonry construction.
Other wall substrates may require other fas-
tening materials. Seek specialist advice when
in doubt.
Set the ON / OFF switch
11
to the position
“ON“ to start the operation of the product
(Fig. G).
Note:
In the “OFF“ position both the light
and the charging function are disabled.
Attach the product to the mounting plate in
such a way that the hangers
4
of the
mounting plate grip in the receivers
5
on
the back of the product. Slide the product
downwards until the hangers click into place
in the receivers (Fig. B).
After mounting, check that the main unit is
fitted securely.
Replacing the
rechargeable batteries
Note:
Regularly clean the sensor and solar
cell to ensure proper functionality (refer to
“Cleaning and Care“).
Change the rechargeable batteries as follows:
Slide the product upwards until the hangers
4
release from the receivers
5
(Fig. B).
Remove the product from the wall.
Set the ON / OFF switch
11
to position “OFF“
(Fig. G).
Loosen the fixing screws of the battery
compartment lid
8
and remove these
(Fig. D).
Remove the rechargeable batteries
10
from
the battery compartment
9
and replace
these with new rechargeable batteries
10
(Fig. E). Use only rechargeable batteries
10
of the recommended type (see „Technical
data“). Be sure to insert the rechargeable
batteries
10
in the correct direction. It is in-
dicated in the battery compartment.
