17
GB/IE
Unscrew hinge joint
4
to detach the mounting
bracket
3
from the spotlight
10
.
Utilize the mounting bracket
3
as a template
for making the position of the two outer drill
holes.
Then drill these holes and attach the mounting
bracket
3
using the supplied dowels
1
and
screws
2
.
Now attach the spotlight
10
to the mounting
bracket
3
using the previously removed hinge
joint
4
, spring washer
5
and flat washer
6
.
Please make sure that the spring washer
5
and flat washer
6
are located as fig A.
Mounting the solar cell
Make sure you will not be drilling into electrical,
gas or water lines inside the wall. Use a power drill
to drill the holes into the brick wall. Always observe
all safety instructions for the power drill in the ma-
nual for the power drill. Death or injury due to
electric shock may otherwise result.
When selecting the mounting location for the solar
cell
12
, pay attention to the following:
The solar cell
12
needs to be as directly
exposed to sunlight as possible. Even partial
shading of the solar cell
12
during the day can
have a significant influence on charging.
Cardinal direction:
Orientation towards the south is optimum. Orienta-
tions with slight deviations towards the west are
preferable to those with slight deviations towards
the east.
Horizontal orientation:
The horizontal orientation of the solar cell depends
on the geographic latitude of the mounting loca-
tion. In central Europe, and angle of 30°–40° is
ideal.
A mounting plate with 6 drill holes for screws is
located at the back of solar cell
12
.
Mount the solar cell
12
at the designated loca-
tion using the 4 small screws
13
and dowels
15
. Depending on the topography of the
mounting location, you can freely choose 4 of
the drill holes in the mounting plate; however,
you should ideally select 2 drill holes on the
right and left each (see fig. B).
Then lay the solar cable plug
14
and connect
the plug to the solar electricity socket
8
of the
spotlight
10
.
The solar cell
12
is connected to the mounting
plate via a swivel joint. Orient the solar cell
12
in a manner that ensures maximum exposure to
sunlight.
Preparing the product for use
Switching the motion detector
on and off
Press the ON / OFF switch
11
into the ON po-
sition to switch on the motion detector
9
.
Press the ON / OFF switch
11
into the OFF po-
sition to switch off the motion detector
9
.
Setting the lighting duration
Turn the rotary control TIME
18
on the bottom
of the motion detector
9
clockwise to increase
the duration of the illumination. The lighting
duration can be adjusted within a time window
of approx. 5s +/-2s to 5 min +/-1min.
Adjusting the sensitivity of
the sensor
Turn the rotary control SENS
17
on the bottom
of the motion detector
9
clockwise to in-
crease the sensitivity of the sensor.
Note:
The motion detector responds to heat
radiation. When outdoor temperatures are low,
it is more sensitive to body heat than when out-
door temperatures are warm. Be sure to regu-
late the sensitivity of the sensor over the course
of the year.
