18 GB/IE
Setting the daylight level
Turn the rotary control LUX
16
on the bottom of
the motion detector
9
clockwise to increase
the daylight level. In position , the motion
detector only responds at pitch-black night
(approx. 5 lx). In position , the motion
detector also responds at daylight levels, as
long as about 20,000 lx are not exceeded.
Orientating the
motion detector
Loosen the fastening screws
7
of the motion
detector
9
.
Turn the rotary control LUX
16
to position .
Orient the motion detector into the central
region of the desired coverage area.
Move about through the coverage area until
you are satisfied with the response characteris-
tics of the motion detector. To find the proper
orientation, change the position of the rotary
control SENS
17
or the orientation of the
motion detector.
Re-tighten the fastening screws
7
to fix the ad-
justment.
Turn the rotary control LUX
16
to the desired
position. These can be determined during the
dawn or twilight hours during which the spot-
light
10
should respond. Slowly turn the rotary
control LUX
16
clockwise until it reacts to
movement within the coverage area.
Cleaning and storage
Press the ON / OFF switch
11
into the OFF po-
sition if you will not be using the product and
want to store it.
Check the motion detector
9
and the solar
cell
12
for dirt regularly. If dirt or is present,
remove it to guarantee flawless function of the
product.
Especially during the winter, keep the product
free from snow and ice.
Clean the product with a lint-free, slightly moist
cloth and mild cleaning agent.
Troubleshooting
=
Fault
= Cause
= Solution
=
The product does not switch on.
= The ON / OFF switch
11
is in the OFF position.
= Press the ON / OFF switch
11
into the ON
position.
= The rotary rotary control LUX
16
is adjusted
too dark.
= Adjust the rotary control LUX
16
so it is brighter.
= The motion detector
9
is dirty or is incorrectly
oriented.
= Clean the motion detector
9
or reorient it.
= The sensitivity of the motion detector
9
is too
low.
= Readjust the sensitivity of the motion detector
9
(see section “Adjusting the sensitivity of the sen-
sor”).
= The rechargeable battery is discharged.
= Charge the rechargeable battery (see section
“Charging the rechargeable battery”).
=
The product also switches on when it
is light out.
= The rotary control LUX
16
is adjusted too bright.
= Adjust the rotary control LUX
16
so it is darker.
=
The light flickers.
= The rechargeable battery is almost discharged.
= Charge the rechargeable battery (see section
“Charging the rechargeable battery”).
=
The rechargeable battery loses its
charge after a short time.
= The plug connection of the solar cell
12
and
spot light
10
has come loose.
= Refasten the plug connection at the product.
= The solar cell is dirty.
= Clean the solar cell.
