12
COMPUTER OPERA
TION
(2) In STOP mode, press MODE button to set up TIME (0:00~99:00), DISTANCE (0.00~99.90), and CAL (0~9990). The
blinking function is for presetting. (figure 5). Press SET button to set each target. When you set the TIME, DISTANCE, or
CAL, then Press START the function will countdown from the number you set to zero. If one of the function countdown to
zero, there will have eight beep sound to remind you that you are reach to the target. The treadmill will stop operation.
Press RESET button to clear the function value to zero.
(3) In STOP mode, hold pressing RESET button for 2 seconds to make all function values RESET.
3. When the exercise is stop, and all buttons are not operated for over 4 minutes, the monitor display shows up the clock
time and room temperature that is called sleep mode. At the moment, other functions are off. (figure 6). All previous
preset data and training data are kept, and show up when any buttons is pressed or exercising starts again in the sleep
mode.
4. When the safety key is not installed, pressing START/STOP button is failed. The system will stop automatically if the
safety key is not positioned during exercising. At this moment, the motor speed will slow down to 0.
Figure 4
Figure 5
Figure 6
