13
Lubrication
The treadmills have already been spread with "Silicone Oil" in advance before leaving the manufacturing plant. Silicone oil is without
volatility and has gradually permeated through the running belt. There will be no need to re-spread the oil in normal circumstances.
To maintain the running belt, we have included a small bottle of "Silicone Oil". "Silicone Oil" may be re-spread once the resistance
has been increased and the running belt starts rubbing against the running deck. To hold open the running belt from two sides,
apply the silicone oil with an even motion on the center of the running deck. Allow the silicone oil to 'set' for one minute before using
the treadmill.
Attention:
Only use "Silicone Oil" lubricants for this equipment.
In addition, do not add any other oil ingredient; otherwise the
treadmill will be damaged. Do not over-lubricate the walking board. Excess lubricant should be wiped off with a clean
towel.
Running Belt Adjustment:
The running belt is adjusted at the factory; it may come loose during transportation and from use. After prolong use of running, the
belt will stretch out. If the running belt is shifting to the left, turn on the main power switch of treadmill and let the running belt run at
the speed of 2~3 km/h. Using the hex key provided, turn the left rear roller adjustment bolt 1/4 turn in the clockwise direction. You
should see the belt start to correct itself by moving back toward the center. Repeat the above procedure until the running belt is
centered. If the running belt is shifting to the right, turn on the main power switch of treadmill and let the running belt run at the
speed of 2~3 km/h. Using the hex key provided, turn the right rear roller adjustment bolt 1/4 turn in the
clockwise direction. You should see the belt start to correct itself by moving back toward the center. Repeat
the above procedure until the running belt is centered. If the running belt is slipping during use, turn off and
unplugged the treadmill. Using the hex key provided, turn both left and right rear roller adjustment bolts 1/4
turn in the clockwise direction for the same distance, turn on the main power switch of treadmill and let the
running belt run at the speed of 2~3 km/h. You should now walk on to the running belt to determine if the
running belt is still slipping. Repeat the above procedure until the running belt is not slipping.
LUBRICA
TION
& RUNNING
BEL
T
ADJUSTMENT
