Mode 2: Alternating foot/calf massage
The compression wraps will go through 1 unique cycle as described below.
1. The feet will inflate.
2. The air pressure will hold.
3. The feet will deflate.
4. The calves will inflate
5. The air pressure will hold.
6. The calves will deflate.
Operation
1. Slip on each massager, keeping your feet flat on the bottom. Note that each is marked L and R for each foot.
2. Use the strap to tightly secure your foot into the massager.
3. Use the strap to tightly secure your leg into the massager.
4. Move your foot to make sure that the massager is securely fastened.
5. Insert the two air pressure connections into the controller.
6. Press the power button. While on, the LED will stay on.
7. Adjust the air pressure strength as needed, by pressing the air pressure button. The LED about the button indicates the current
setting (green=low, yellow=medium, red=high).
8. Select either mode 1 or 2 as desired.
NOTE: the device will automatically shut off after 15 minutes.
For best results, do not use the leg massager for more than an hour.
Care and maintenance
• Store the product in a dry place, away from moisture and direct sunlight.
• Wipe clean with a dry towel.
Troubleshooting
4
Problem Cause
Solution
The device does not work.
The unit is not connected to a
power source.
Make sure the unit is fully
connected to the power.
The power button was not
pressed.
Press the power button.
The device suddenly stopped
working.
The unit was running more
than 15 minutes.
Restart the unit to resume use.
Specifications
Rated voltage: 12V
Power consumption: 12W
Default time: 15 min.
Customer service
supportlfc@camarketing.com
1-888-390-7622
Distributed by
C&A Marketing, Inc.
114 Tived Lane East
Edison, NJ 08837 USA
Europe: C&A Europe
167 Hermitage Road
Crusader Industrial Estate
London N4 1LZ
United Kingdom
Made in China
LIVEFINE is a trademark of
C&A IP Holdings, LLC. in the U.S.
©2017 All right reserved
