13
BOLT (K)
SPRING WASHER (B)
FLAT WASHER (D)
WAVY WASHER (J)
PEDAL ARM
CRANK
PEDAL ARM WHEEL
GUIDE RAIL
CONSOLE MAST
PRE-INSTALLED BOLTS
& WASHERS
CONSOLE CABLE
MAIN FRAME
ASSEMBLY
STEP 3
A
Open
HARDWARE FOR STEP 3
.
B
Remove
PRE-INSTALLED BOLTS AND
WASHERS
from
MAIN FRAME
.
C
Carefully pull the
CONSOLE CABLE
through
the
CONSOLE MAST
using the twist tie located
inside the
CONSOLE MAST
.
D
Attach
CONSOLE MAST
to
MAIN FRAME
using
PRE-INSTALLED BOLTS AND
WASHERS
.
E
Slide
WAVY WASHER (J)
over
CRANK
followed by
PEDAL ARM
as shown. Rest
PEDAL ARM WHEEL
on
GUIDE RAIL
.
F
Attach the
PEDAL ARM
to the
CRANK
using
1
FLAT WASHER (D)
, 1
SPRING WASHER
(B)
and 1
BOLT (K)
.
G
Repeat steps E–F on the opposite side of the
elliptical.
BOLT (K)
20 mm
Qty: 2
SPRING
WASHER (B)
15 mm
Qty: 2
FLAT
WASHER (D)
20 mm
Qty: 2
WAVY
WASHER (J)
22.5 mm
Qty: 2
HARDWARE FOR STEP 3
:
NOTE: Be
careful not
to pinch any
wires while
attaching the
console mast.
Summary of Contents for LS10.0E
