Attachment / removal of accessory heads:
The heads are a compression fit into the muscle massager output socket.
Simply align the required head shaft with the socket and firmly press until
the shaft is fully inserted. To remove, simply pull the attachment to withdraw
from the socket.
WARNING:
To avoid personal injury, never attempt attachment or removal
when the massager is in operation.
Charging and Battery Life
Charging
For best results charge the massager
gun
before use.
1.
Insert the small plug end of the power adaptor into the charging socket
of the muscle massager
gun
.
2.
Plug the adaptor CHARGER into an electrical outlet.
3.
The power button and speed indicator will flash when charging. When
the muscle massager is fully charged, the speed indicator stays on (blue).
4.
Touch and hold the power button for 3 seconds to show the battery
capacity (charge status), this can be done when the power is on or off. The
speed indicator has 5 separate lights which show the charge status of the
battery, each indicator light means 20% of the battery capacity. For
example, when two indicator lights are blue, this means there is 40%
capacity of the battery remaining before charging is required.
5.
When the power button light flashes red, without the charger connected,
this means the battery is about to run out of charge. If this occurs, please
stop using, and connect to the charger.
NOTE: The muscle massager
gun
should not be used while it is charging.
2
130 0 886 649
A U
7
