For HELP, call In-Touch
™
at 727.490.5353
Page 17
O
O
O
p
p
p
e
e
e
r
r
r
a
a
a
t
t
t
i
i
i
o
o
o
n
n
n
a
a
a
l
l
l
C
C
C
h
h
h
e
e
e
c
c
c
k
k
k
s
s
s
Caution:
Do not turn on any pump until your hot tub is properly filled with water. Running
any pump without water in your hot tub can cause IMMEDIATE damage, which is not
covered under warranty!
By now you have rechecked your hot tub’s mechanical connections and filled it with water to
about 1” above all jets by adding cold tap water through the pre-filter (if equipped). Turn on
power to the hot tub at the main breaker panel and test the operation of its electrical system. If
you encounter a problem, please reference the troubleshooting guide.
1. Turn on the breaker and test the operation of the Ground-Fault Circuit Interrupter (GFCI)
breaker by pushing the small test button. This should automatically trip the hot tub's circuit
breaker.
DANGER:
If this breaker does not trip, immediately call your electrician. Do not use your
hot tub!
Only if pushing this button successfully trips this circuit breaker should you reset this breaker
and proceed to the next step.
2. Go to the topside electronic control panel. The hot tub first goes into a 5-minute Priming
mode, indicated by “Pr” message. Water heating is disabled during priming. To exit Priming
mode and begin normal hot tub operation, press the
Temp
button.
3. Press the
Jets 1
button. You should hear the high flow hybrid pump turn on, see water
circulating, and see the Jets light illuminate on the panel.
4. Press
Jets 1
again. You should hear the high flow hybrid pump turn on a higher speed.
Caution:
If water is not flowing from the hydrotherapy jets after 2 minutes, turn the power
off at the main panel and bleed air from the system (see page 27). Turn the
power on again. Sometimes momentarily turning the pump off/on will help to
prime. Only do this four times.
5. If the water is running smoothly through the lines, open the zoned manifold air control valve
and you should see an increase in jet pressure. Check and adjust the water and airflow of
every jet if necessary.
Each hydrotherapy jet in your hot tub can be adjusted for massage intensity and directional
flow. Pivot the angle of a jet to achieve an optimal massage.
An air mixture intensifies the level of your massage. Turn the zoned manifold air control
valve counterclockwise to increase the air mixture and clockwise to turn it off.
To minimize heat loss, close all zoned manifold air control valves when your hot tub is not in
use.
Summary of Contents for St. Lucia Series
