HEATER BUTTON
Press to scroll through low heat, high heat and off setting.
WIFI BUTTON
Press to turn WiFi on or off. An illuminated LED indicates that WiFi is turned on. Hold the
button for 3 seconds to enter device pairing mode.
NOTE:
The controls on appliance will lose the memory for all function settings when the switch is set
to the Off Position. When the remote runs out of power or when you change the batteries, only the
flame function will lose memory and will not affect the timer settings, however, the clock may need
adjusting.
3.2
Operating by Remote Handset
•
Make sure the batteries are installed properly in the remote control.
•
The effective range of the remote control is up to 6 meters.
•
Aim the remote control at the remote receiver located at the top-right corner of the firebox.
NOTE
: This is a thermostatic remote control. The remote should always be in the same room as the
fireplace and placed on a flat surface. It must be placed away from the heater so the hot air will not
blow on it and affect thermostatic reading.
