User manual
6
Before use:
Make sure your skin is clean, dry and free of grease.
Epilating is better after a bath or shower.
When you use the epilator for the first time. We advise you to try it on a zone of growth of hairs to familiarize
you in the process of removal of hair.
As hairs are removed from the root, the removal of hair can cause discomfort of the skin the first time as
you use the hair remover. The more you will use the epilator, the more this embarrassment will disappear.
USE
1.
Insert the appliance plug into the appliance socket (1) and then the main plug into wall socket (2) but
you can use it without power cord by charging it before use (check below paragraph “charging”).
2.
You have two sort of epilating head, one for sensitive zone (as armpits) and another one for normal
zone (as legs).
You can change the head by pressing the both sides button (3) and remove the head you don‘t want
to use (4).
Remove the head cap by pulling up the two sides clips, put the cap on the head you want to use by
pushing it down (until you hear a “clip”). Then you can install the head by pushing downward (5) on
the appliance.
3.
Stretch your skin, place the epilator perpendicularly onto the skin.
4.
Slide the button to the one or second speed (6) :
First speed is for areas with little hair growth and where there are bones such as knees.
Second speed is for areas with stronger hair growth
5.
Move the epilator slowly over the skin against the direction of hair growth (7).
6.
Switch off after use by sliding the button (8).
1
2
3
4
5
