www.livoo.fr
Charging
For best performance, fully charge the appliance before use. Insert the cable tip into input and the USB
tip into any other device of your choice (computer, adaptor, powerbank, etc). If you choose computer
charging, time will be longer. With power bank or mobile phone adapter it will charge in 2 hours. If you
want to use your product with an adaptor (not supplied) instead of USB cable, please respect output
mentioned on the product (5V, 1000mAh).
1.
Do not use while charging.
2.
Disconnect the charger when the battery is fully charged.
3.
When charging the epilator for the first time or when it has not been in use for more than 6 months, the
time it takes to charge the epilator may increase.
Before use
Remove the head while pushing the head release button (Figure 2).
Push the head you have chosen until it clicks (Figure 2).
Use of the device
Epilating
Before epilating, wipe away water or sweat on your skin. We recommend using the appliance in an
ambient temperature range of 5 - 35 °C to avoid malfunction.
Push the epilation head (figure 1-a) until it clicks.
Epilating legs or arms (figure 3)
Upwards from the bottom of the leg. Inwards from the outside of the arm.
Epilating underarms or bikini-line (figure 4)
Move in several directions as underarm/bikini line hair grows in different directions. Stretch the skin with
your fingers and move slowly from inside to outside going against the flow of hair.
Note
Hair removal is easier and less painful when the hair is short.
The hair removal is not permanent, so from the 2nd use we recommend that you epilate the underarms
about once a week and the arms and legs about once every two weeks.
The epilator should not be used on the inner side of the upper arms and areas such as elbows or knees
which are prone to sagging.
Shaving
Before shaving, wipe away water or sweat on your skin.
1.
Push the shaving head (Figure 1-b) until it clicks.
2.
Check that the outer foil is not deformed or damaged.
3.
Select the mode by pressing the power switch. Press gently so that the whole blade is in close contact
with the skin.
Foot care
The foot care head cannot be used in a bath or shower.
We recommend using the product within 30 minutes after bathing or showering. With the feet clean,
wipe off any water on the skin. (Each use should be approximately 10 minutes (5 minutes on each foot, 10
minutes total for both feet)
1.
Attach the foot care head (Figure 1-c), push down firmly until you hear a “click”.
2.
Press the power switch once.
3.
Bring the foot care head into contact with the skin, and begin filing (figure 5)
EN
