32
User’s manual
EN
Problem
Cause
Remedy
The work area is not
completely mowed.
Not enough work hours
Extend the working times
Cutting blade with deposits
and/or residuals
Stop the robot safely (see
“Robot safety stop”, page
26). Use protective gloves to
avoid the risk of cutting your
hands. Clean the cutting
blade.
Cutting blade worn.
Replace the blade with
original spare parts (see
“Blade Replacement”, page
35).
Work area is too big
compared to the actual
capacity of the robot
Adjust the work area (see
“Technical Specifi cations”,
page 9).
The batteries are about to
end their life cycle
Replace the batteries with
original spare parts.
The batteries do not
recharge completely
Clean and remove any
oxidizations from the contact
points of the batteries (see
“Robot Cleaning, page 30).
Recharge the batteries for at
least 12 hours.
The “wheel motor error”
LED fl ashes.
(1 or 2 fl ashes of the green
ON LED).
Uneven ground or ground
with obstacles that impede
movement
Check that the lawn to mow
is even and does not have
any holes, stones or other
obstacles.
If so, fi ll in any holes and
remove any obstacles (see
“Preparation and defi ning
the boundaries of the work
areas”, page 15).
One or both motors which
drive the wheel transmission
have broken down
Have the motor repaired
or replaced by the nearest
authorised service centre.
1
2
1 FLASH
right motor error
2 FLASHES
left motor error