33
User’s manual
EN
Problem
Cause
Remedy
The fl ashing of the LEDs
signals a “motor/blade error”.
3 fl ashes of the green ON LED.
Cutting blade damaged.
Replace the blade with
a new one (see “Blade
Replacement”, page 35).
Cutting blade engulfed by
residuals (tape, ropes, plastic
fragments, etc.)
Stop the robot safely (see
“Robot Safety Stop”, page
26). Use protective gloves to
avoid the risk of cutting your
hands. Remove the cause of
the fl ood from the blade.
The robot was started too
close to obstacles (less than
1 m. (40.0 in.) away) or in
the presence of unexpected
obstacles (fallen branches,
forgotten objects, etc.).
Stop the robot safely (see
“Robot safety stop”, page
26).
Remove the obstacles and
restart the robot.
Electric motor failure
Have the motor repaired
or replaced by the nearest
authorised service centre.
Too high grass.
Increase the cutting height
(see “Cutting height
adjustment,” page 22).
Carry out a preliminary
cutting of the area with a
normal lawnmower.
The “tip-over error” LED
fl ashes.
4 LEDs fl ashing
consecutively.
Ground with too much slope
or with undefi ned borders.
Check the installation rules.
“See page 15 and following
pages.”
Tip-over sensor failure.
Try to restart the robot. If the
problem persists, have the
robot repaired by the nearest
authorised service centre.
The robot does not turn on.
Batteries in protection under the
minimum level.
Connect the robot to the
recharger and wait for up to
4 hours.
If it still does not turn
on, contact the nearest
authorised service centre.
3
4
3 LAMPEGGI FLASHES
blade error
4 FLASHES
tip-over error