10
www.lloytronhelpdesk.com
TROUBLE SHOOTING
QUERY
SOLUTION
No blue light on the bell push when pressed
Check the battery is inserted is correct polarity and
is not dead.
No Sound when bell push is pressed, bell push
illuminates, and Tune sounds when I press Chime
Replay on Chime Unit
Check that switch settings inside the bell push are
on default.
Try to re-link the bell push to the receiver by following
the section on link/programme devices.
No Sound when bell push is pressed, bell push illu-
minates, and NO Tune sounds when I press Chime
Selection on Chime Unit
Ensure mains switch is plugged in and switched on
at the wall.
Chime unit is activating every few minutes.
Check the sensor has not been broken or is sticking
or there is water inside the unit
For further assistance and troubleshooting or on the range of MIP System™ products visit
www.doorbellsolutions.com or contact customer services.
