E-mail support
techsupport@lmicorporation.com
LMI Corporation
Phone support
(810) 714-5811
Form: CA 045
May 5, 2005
C:\Documents and Settings\timmartin\Local Settings\Temporary Internet Files\OLK9\CA
045 LMI 241-BWV2 to 440 or 501.doc
Page 6 of
12
Gap Setup
This configuration will produce an actual value for gap readings
12.
To assign the gage file name, press
▲
or
▼
to highlight “G3”* in the “Gage List” and press
<enter> on the collector.
*G3 has the ability to support “sub files”. These are files that allow multiple styles of gages to be used by the same collector.
To create sub files highlight G2 and press
►►
, this will create a sub file of G3a. Each press of
►►
creates another sub
file. The balance of this instruction will be based on G3
13.
Use the
▲
,
►
,
◄
, or
▼
to highlight the first character of the new file name then press <enter>,
repeat the process until the gage file name is spelled. Then press
►►
to accept the new name.
14.
Press the
►
to “Configure”, by default the
screen should read as follows.